Table of Contents
Advertisement
setup screen
To make recording on the SD memory
1. Check the memory card's <Free> size and <Total> size.
2. If there are sufficient free space, set the device to <On>.
Otherwise, check the stored data and if you find them not important, then click
<Format> to format the SD memory.
Some frames may be skipped if the SD memory card operates at the lower speed than recommended.
For more details, refer to "Recommended SD/SDHC Memory Card Specifications". (Page 10)
For a SD memory card with a large capacity, the formatting will be slowed down accordingly.
The data traffic will increase when the encoder is set to higher resolution, higher bit rate, and/or higher
framerate.
If there is too much data traffic, some frame may be skipped although it is stored in a full frame.
3. Specify the storage action.
Record profile : Shows recording profile's codec type.
Overwrite : If the SD memory is full, this will delete old data and store new data in
replacement.
Pre-alarm duration : Specify the time point before the occurrence of the alarm;
starting from the time point, the images will be transferred. You can specify up to
5 seconds before the occurrence of the alarm.
Post-alarm duration : Specify the time point after the occurrence of the alarm; to
the specified time point, the images will be transferred. You can specify up to 120
seconds after the occurrence of the alarm.
Normal : Make recording at a certain frame rate.
Event : Set the recording type for a certain event that occurs.
4. Specify the <Normal record setup>.
Always : Always save recorded video in the SD memory card.
If set to Always, the activation time cannot be changed.
Only scheduled time : Records only on the specified time of the specified day of week.
[Clear (
5. When done, click [Apply (
70_ setup screen
)] : Reset all settings.
)].
Hide quick links:
Advertisement
Table of Contents
