Table of Contents
Advertisement
13 Configuring the network settings [Network]
IPv4 network
[Network Settings]
Select the method of how to configure the IP address from the following.
Static: The IP address is configured by entering manually on "IP address(IPv4)".
DHCP: The IP address is configured using the DHCP function.
Auto(AutoIP): The IP address is configured using the DHCP function. When the DHCP server is not
found, the IP address is automatically configured.
Auto(Advanced): Using the DHCP function, network address information is referred to, and an unused
IP address is configured to the unit as a static IP address. The configured IP address is automatically
determined within the subnet mask range by the unit. When the DHCP server is not found, the IP
address is set to 192.168.0.10.
Default: Auto(Advanced)
Note
When "Auto(AutoIP)" is selected and the IP address cannot be obtained from the DHCP server, an IP
address not used in the same network will be searched within 169.254.1.0 - 169.254.254.255.
[IP address(IPv4)]
When not using the DHCP function, enter the IP address of the unit. Do not enter an IP address already in use
(for the PCs and the other network cameras).
Default: 192.168.0.10
Note
Multiple IP addresses are unavailable even when using the DHCP function. Refer to the network
administrator for further information about the settings of the DHCP server.
[Subnet mask]
When not using the DHCP function, enter the subnet mask of the unit.
Default: 255.255.255.0
[Default gateway]
When not using the DHCP function, enter the default gateway of the unit.
Default: 192.168.0.1
Note
Multiple IP addresses for the default gateway are unavailable even when using the DHCP function.
Refer to the network administrator for further information about the settings of the DHCP server.
[DNS]
Determine how to set the address of the DNS server by selecting "Auto" (obtain the address automatically) or
"Manual" (enter the address of the DNS server). When "Manual" is selected, it is necessary to configure the
settings for the DNS.
When using the DHCP function, it is possible to obtain the DNS address automatically by selecting "Auto".
Refer to the network administrator for further information about the settings.
Default: Auto
[Primary server address], [Secondary server address]
When "Manual" is selected for "DNS", enter the IP address of the DNS server. Refer to the network
administrator about the IP address of the DNS server.
Default: None (blank)
IPv6 network
[Manual]
Select "On" or "Off" to determine whether or not to manually configure the IP address for IPv6 network (IPv6
address).
58
Operating Instructions
Advertisement
Table of Contents
