Bosch ICP-EZM2 System Reference Manual page 27
Easy series control panel
Hide thumbs
Also See for ICP-EZM2:
- Installer's manual (80 pages) ,
- System reference manual (126 pages) ,
- Quick start manual (24 pages)
Table of Contents
Advertisement
Easy Series Control Panel
2.
Figure 3.1: Control Center Address Switch
1
2
1.
Notice!
Mount the base to a non-metallic surface that is near the primary entry/exit door.
If you install more than one control center, ensure that there is at least 1.2 m between each
control center.
Avoid mounting the control center near existing phone lines.
Avoid mounting the control center near other electronic devices.
2.
3.
4.
Refer to Control Center, page 70 for an overview of the various control center display states.
Bosch Security Systems, Inc.
If you install more than one control center, each control center must have a unique
address. Valid addresses are 1 to 4. Refer to the figure below for the location of the
address switch.
Control Center's front cover
Address switch's default settings
Mount the control center base to the desired surface using the appropriate mounting
holes. Use the built-in level in the control center base as a guide.
Connect the control center data bus terminals to the control panel data bus terminals.
Refer to System Components and Wiring, page 18.
Connect the control center audio bus terminals to the control panel audio bus terminals.
Twisted pair wiring is recommended for audio bus terminals. Refer to System Components
and Wiring, page 18.
Reconnect the control center and base, and then lock the control center.
System Reference Guide
System Installation and Configuration | en
2014.09 | 01 | F.01U.306.221
27
Advertisement
Table of Contents
