AMAX panel 4000 / AMAX panel 4000
EN
5.7.4
Status Indicator
On
Momentarily on
Flashes rapidly for less than one
minute
Flashes rapidly for more than
one minute
Off
Table 5.12: RF 3227E RF System Status Indicator
5.8
RF Radion Receiver
5.8.1
General
RADION receiver OP is a wireless receiver that connects the RADION Wireless System
components to the AMAX panel 3000 / 4000. Features include:
–
–
–
–
Installation
Use the provided anchors and screws to mount the receiver in locations accessible for future
maintenance. Mount the receiver onto a wall.
For best reception, place the receiver in a central location among the transmitters. In
situations where there is a large distance between the transmitter and receiver, it might be
necessary to install receivers for optimum results.
5.8.2
Address Setting
Set rotary switch to value 1. The AMAX panel supports one receiver only.
5.8.3
Wiring
Connect the RADION receiver to bosch option bus. The cable distance to the AMAX panel may
not exceed 300 meters.
5.8.4
Status Indicator
On
Off
Bosch Sicherheitssysteme GmbH
LED Condition
Cover and wall tamper protection
RFID and configuration data are contained in persistent memory
Detection and reporting of radio frequency interference
Supports two types of device enrollment
LED Condition
Normal operation
Power failure or wiring failure
Optional Modules and Peripheral Devices | en
Normal Operation
The receiver has acknowledged receiving a message from a
compatible transmitter.
The receiver is being programmed with zone and
transmitter IDs from the AMAX panel. This condition occurs
during system initialization (power up), or when new zone
information is programmed into the system. The rapid
flashing lasts for less than one minute.
The receiver has failed power-up self tests. Replace the
receiver.
Power failure or wiring failure
Installation Guide
Denotation
Denotation
2014.4 | 01 | F.01U.267.112
21