Check Treadmill Level - GE Series 2000 Installation Instructions Manual
Hide thumbs
Also See for Series 2000:
- Operator's manual (28 pages) ,
- Interconnection and wiring manual (36 pages)
Table of Contents
Advertisement
Check Treadmill Level
2021403-028A
WARNING
INJURY TO PERSON — The treadmill will reach
maximum elevation speed. Injury may result.
Make sure you monitor the site at all times.
Make sure there are no customers or patients near the
treadmill during calibration
5. Below the service port are two prongs (pins). Place a screwdriver between the
two self-calibration prongs to short the circuit and activate the self-
calibration software. The software calibrates the speed and grade from the
minimum points to the maximum points.
6. Make sure you turn the Series 2000 treadmill power off before you proceed to
the next section.
NOTE
Before you check the treadmill level, make sure that it has been moved to its
final destination.
1. Use the controlling equipment to set the treadmill elevation to 0.0%.
2. Check the treadmill level with a carpenter's level.
3. If the treadmill is uneven, adjust the feet at the rear of the treadmill until it
is stable.
For stability, use one shim of the right thickness (rather than several thin
shims) to achieve the proper level.
If necessary, use longer shims to accommodate the maximum treadmill
elevation. The treadmill wheels must not roll off the shims. Verify that the
shim lengths exceed the wheel movement when the treadmill is fully
elevated.
4. If you cannot level the treadmill safely with shims, move the treadmill to
another location.
Series 2000 Treadmill
7
Hide quick links:
Advertisement
Table of Contents
