Table of Contents
Advertisement
StarBoardLink EZ
Recognition-Related Problems
Problem
Touch Sensor Error
(Insufficient USB
bandwidth)
Input-Related Problems
Problem
The input position does not
match.
The position
cannot be
aligned properly.
What to check
Is a high-speed USB
device connected to the
USB host controller used
to connect the StarBoard?
What to check
Has position alignment
been performed properly?
Other than the above
Have the StarBoard and
projector been placed in the
proper orientation?
Is the PC screen being
projected inside the
StarBoard's input area?
StarBoard Software files
may be broken or
installation may not be
complete correctly.
Other than the above
4-2
What to do
Be sure to connect the StarBoard and
any high-speed USB devices to
separate USB host controllers.
Be sure to use a USB hub in the case of
PCs with only one USB host controller.
What to do
Perform proper position alignment.
Contact a support center.
Adjust the position of the StarBoard
and the projector. If undue correction
is performed, it may not be possible to
align the position properly.
Make sure the PC screen projection is
contained within the StarBoard's input
area.
（For details on the input area, see
page 1-4 of this User's Guide.）
Uninstall the StarBoard Software and
then re-install it.
（For details on installing StarBoard
Software, see the StarBoard Software
x.x Installation Guide.)
Contact a support center.
Appendix
English
- Quick Links:
- Installing the Starboard Software
Hide quick links:
Advertisement
Table of Contents
