StarBoardLink EZ
・Installing to walls where magnets cannot be used.
(1) Align the center of the plate with the center of the projection area, 12cm (5 inches) above the
projection area, and install so it is parallel with the edge of the projection area.
Plate
Plate Installation
When installing the plate, use the double-sided tape attached to the back of the plate.
Plate (rear side)
Fixing Screws
To prevent the plate from falling, fix it in place with screws after attaching with the
double-sided tape.
(Use the 6 included screws)
Plate (front side)
12cm (5inch)
Projection Area
Peel off the separating paper
2-5
Assembly and Setup
English