Table of Contents
Advertisement
Other Settings
Changing or disabling the operation start/finish sounds
A sound is emitted when an operation starts or finishes.
You can select one of three settings for the sound.
Press
Hold the
The setting changes as follows each time the button is held for 3 seconds.
Melody
(default setting)
Press
Turning the power off completes the setting.
This setting will be saved.
To change the setting, perform the same operation.
About 10 minutes before an operation finishes, a warning sound is emitted as a notification.
(The remaining time before the sound is emitted may vary during [WASH DRY] and [DRY] operations, depending
on the selected program and settings.)
You can enable or disable the sound.
To change the default setting (i.e., to disable the sound)
Press
Hold the
The setting changes as follows each time the button is held for 3 seconds.
(Ignore the sound that is emitted when [START] is pressed.)
Sound enabled (default setting)
Beeps twice and emits the warning
sound to indicate setting.
The sound emitted to indicate change will differ depending on the operation start/finish sound setting.
Press
Press
Turning the power off completes the setting.
When a spin cycle is repeated to correct concentration of laundry to one side, the warning sound is not emitted.
This setting will be saved.
To change the setting, perform the same operation.
64
To change the default setting
to turn on the power.
button for at least 3 seconds.
Buzzer
to turn off the power.
Disabling the 10-minute warning sound
to turn on the power.
button for at least 3 seconds.
to pause.
to turn off the power.
No sound
Sound disabled
Beeps three times to indicate setting.
Hide quick links:
Advertisement
Chapters
Table of Contents
