Table of Contents
Advertisement
4.4.3 Setting Up the LightPixAE20 in CONFIGURATION Mode
In CONFIGURATION mode, you can set up the main, operation and finder units and
also set and save the inspection/communication conditions as shown below.
Refer to section 4.7 "Detailed Functions in CONFIGURATION Mode" for details of
each function.
The number in < > in the table below represents the button number of the operation
unit (see the figure on the right).
Function
Upper: Function name and options
to be displayed
Middle: Name
Lower: Description
Display when starting
I.SETT: (CANCEL / SET)
Initial Setting (default):
Initializes the settings
SAVE: (CANCEL / SAVE)
SAVE function:
Saves the current settings
TEACH: (OK / OKNG)
Teaching: OK only/OK&NG:
B.L.PTN:
(ON/OFF10/OFF30/OFF60)
Backlight Pattern function:
Sets the backlight of the finder
unit OFF
L.ON.OF: (ON / OFF)
LED On/Off function:
Allows you to select whether or
not to use the built-in LED light
V.IMG1 ~ 8:
V.Image1 ~ 8:
Displays up to eight saved images
and the data detected when the
image was saved
SV.IMG: (OFF / ALL / NG)
Auto Save function:
Allows you to set to save the
settings automatically
62
Display on the operation unit
(The left LCD display shows default settings.)
images are saved. When the image is saved, the detection data are
displayed. When switching the image numbers, hold down the <7> and
<8> button.
If you want to initialize the settings,
select "SET" and press the <6> button
for approximately three seconds.
If you want to save the settings, select
"SAVE" and press the <6> button for
approximately three seconds.
Allows you to select whether you want
to execute a teaching for OK products
only or both OK product and NG
product
↑The detection data are displayed if any
Advertisement
Table of Contents
