Table of Contents
Advertisement
4.3
Units (Saddle section: MJ-1104)
[A] Saddle unit
(1)
Take off the front lower cover.
P.4-4 "[E] Front cover / Front upper cover
/ Front lower cover"
(2)
Remove 3 screws, and then take off the SDL
board cover.
(3)
Release the harness out of 3 clamps, and
then disconnect each connector of CN10 and
CN13 on the SDL board.
(4)
Place a table beneath the pulled-out saddle
unit to steady it.
Note:
Store (flip up) the saddle unit support before
placing a table beneath the unit.
(5)
Remove 8 screws and store the right and left
rails.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
SDL board
Clamp
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 26
SDL board cover
Fig. 4-71
Fig. 4-72
Table beneath
Saddle unit
support
Fig. 4-73
Hide quick links:
Advertisement
Table of Contents
