Table of Contents
Advertisement
[E] Front alignment motor (M5)
(1)
Take off the grate-shaped guide.
P.4-10 "[N] Grate-shaped guide"
(2)
Release the harness out of the clamp, and
then disconnect the relay connector.
(3)
Remove 2 screws, and then take off the front
alignment motor.
[F] Rear alignment motor (M6)
(1)
Take off the grate-shaped guide.
P.4-10 "[N] Grate-shaped guide"
(2)
Remove 2 screws, and then disconnect the
relay connector to take off the rear alignment
motor.
[G] Transport motor (M7)
(1)
Take off the rear cover.
P.4-6 "[G] Rear cover"
(2)
Remove the spring, and then loosen 2
screws to free the belt tension.
Note:
When installing the transport motor, loosen
the 2 screws of the tension plate after the
spring is hooked.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Front alignment motor
Relay connector
Rear alignment motor
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 66
Clamp
Relay connector
Fig. 4-186
Fig. 4-187
Belt
Spring
Fig. 4-188
Hide quick links:
Advertisement
Table of Contents
