Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01091
Rev: 3
25
25.1
Disable or re-enable (H2)
A whole zone, one or more alarm points within a zone and/or control
outputs can be disabled via menus H2/B1-B3. This possibility can be
used when a temporary disablement is wanted (e.g. craftsmen working
in the premises, etc.).
A disabled alarm point will not activate Pre-warning, fire alarm or
fault.
NOTE! When a whole zone is disabled, the addressable manual call
points will not be disabled.
individually disabled (as alarm points).
Zones 01-32 can be disabled via menu H2/B1.
All alarm points (zone / address) can be individually disabled
via menu H2/B2.
All outputs can be individually disabled via menu H2/B3.
Disabled output will stay in (or return to) the normal condition
for the output respectively.
NOTE!
All Interlocking outputs can be individually disabled via
menu H9/C4.
The COM loop can be disabled via menu H5/A1.
A zone line input can be disabled via menu H5/A2.
Don't forget to re-enable (via menus H2/B4-B9) or use automatic re-
enablement for zones and alarm points.
Disablements are indicated by LED "Disablements" (L8) and are also
79
shown in the display
. An example:
Zone 01 is disabled
More... is indicating two or more disablements.
Disablements (and faults) are indicated by a 2-sec. beep when an open
EBL128 door is being closed.
Disable zone (H2/B1)
When a whole zone is disabled, all alarm points within the zone are
disabled excluding the addressable manual call points.
All zones can be disabled. Disabled zones are listed in menu H4/U1.
78
This is not valid for the
conventions. In these conventions also the addressable manual call points
will be disabled.
79
See chapter "The display in EBL128", page 20 regarding priority order.
81
EBL128 Operating Instructions V1.1.x
78
When absolutely required, they can be
More...
VdS
(German), Australian and New Zealand
78
Advertisement
Table of Contents
