Motorola G24 Guide Developer's Manual page 61
At commands
Hide thumbs
Also See for G24 Guide:
- Developer's manual (101 pages) ,
- Developer's manual (86 pages) ,
- User manual (260 pages)
Table of Contents
Advertisement
AT Command
+MCWAKE
+MGGIND
+CFUN
+ICF
S97
+MRST
+TWUS
+TWUR
+TASW
+TADIAG
READY
+MPSU
+MIOC
+MIOD
+MMAD
+MPCMC
+MVREF
Audio
General Audio Setup Commands
+CRTT
+VTD
+VTS
+CALM
+MDMIC
+MMICG
December 31, 2007
Table 1-1: AT Commands (Cont.)
Description
This command displays reports on the status of the GPRS/GSM
coverage.
This command configures the service indicator on pin 49 of the 70
pin connector to be GPRS or GSM.
This command shuts down the phone functionality of smart phones
and PDAs with phone capabilities.
This command determines the local serial port start/stop
(asynchronous) character framing used by the DCE when accepting
DTE commands and transmitting information text and result codes.
This command indicates whether an antenna is physically connected
to the G24 RF connector.
This command enables customer software to perform a hard reset to
the G24 unit.
This command is used to set the wakeup reason(s).
This command is used to query the wakeup reason(s).
This command controls the antenna switch mechanism.
This command queries actual ADC values of the antennas.
This unsolicited notification indicates UART is ready.
This command defines the functionality of the second physical
UART.
This command defines the G24 8 GPIO pins data value.
This command defines the G24 8 GPIO pins configuration.
This command reads and monitors digital value from a specified
ADC.
This command defines whether the PCM clock is generated
continuously or not, when module is in digital audio mode.
This command defines the behavior of Vref regulator.
This command plays one cycle of a ring tone, stops the cycle in the
middle, and sets the ring tone to be used.
This command handles the selection of tone duration.
This command transmits a string of DTMF tones when a voice call
is active.
This command handles the selection of the G24's alert sound mode.
This command enables/disables the setting of microphone gain
values by +MMICG in digital audio mode.
This command handles the selection of microphone gain values.
AT Commands Reference Manual
Chapter 1: Product Features
Page
Page 3-202
Page 3-203
Page 3-204
Page 3-205
Page 3-206
Page 3-207
Page 3-207
Page 3-209
Page 3-209
Page 3-210
Page 3-211
Page 3-211
Page 3-213
Page 3-217
Page 3-219
Page 3-226
Page 3-227
Page 3-247
Page 3-250
Page 3-251
Page 3-245
Page 3-246
Page 3-246
1-27
Hide quick links:
Advertisement
Table of Contents
