HP D6030A - NetServer - E50 Installation Manual page 68
Hp netserver e 200 installation guide
Hide thumbs
Also See for D6030A - NetServer - E50:
- User manual (85 pages) ,
- Getting started (57 pages) ,
- Installation manual (46 pages)
Table of Contents
Advertisement
Chapter 9
4. Verify the display's contrast and brightness settings are correct.
5. Verify all internal cables are properly connected and all boards firmly
seated.
6. Verify the processor module is fully seated in the slot on the system board.
7. Verify all DIMMs are installed correctly and fully seated.
8. Verify the DIMMs are aligned in the slots.
After Installing an Accessory:
1. Turn off the monitor, the computer, and any external devices.
2. Unplug all cables from the power outlet.
3. Remove the cover.
4. Check the following:
If you have installed an accessory board, verify the board is firmly
seated in its slot and any switches or jumpers on the accessory board
are properly set.
Refer to the instruction manual provided with each board.
Check all internal cabling and connections.
If you have changed any switches on the system board, verify each one
is properly set.
5. Replace the cover and connect all cables.
6. Turn on the monitor and computer.
7. If the NetServer still does not work:
Repeat steps 1, 2, and 3 of this section.
Remove all accessories, except the primary boot hard disk drive and
AGP video board.
Replace the cover and connect all cables.
Turn on the monitor and the computer.
If the NetServer now works, replace the boards and accessories one at a
time to determine which one is causing the problem.
If a POST Error Message Appears:
If an error occurs during the power-on self test (POST) a text error message
usually displays. A text error message would be, "keyboard error or no keyboard
present." Refer to Table 9-1 for the text error messages.
62
Troubleshooting
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
