HP D6030A - NetServer - E50 Installation Manual page 29
Hp netserver e 200 installation guide
Hide thumbs
Also See for D6030A - NetServer - E50:
- User manual (85 pages) ,
- Getting started (57 pages) ,
- Installation manual (46 pages)
Table of Contents
Advertisement
Chapter 4
Max Number of
Interface
Types
IDE-2
Ultra Wide
SCSI
Channel A
* The primary IDE (IDE-1) cable is connected to the factory-installed
CD-ROM drive with a second IDE connector provided for an IDE hard drive
or optional IDE tape backup device. The secondary (IDE-2) IDE connector is
available for the SCSI model of the NetServer, but is limited by the number of
SCSI drives installed. An additional IDE cable for IDE-2 is required if not
configured with the original order.
** SCSI channel A can support up to 4 devices. However, to get the
maximum number of SCSI hard drives installed (4) may require using the
IDE-1 cable for the boot drive.
Devices
Possible
Installed Devices and Addresses
2*
Two additional IDE hard drives in the
removable mass storage cage (shelves
4, 5, 6, and 7) are limited by the
number of SCSI drives installed. The
removable mass storage cage is limited
to 4 drives.
up to 4**
Up to four installed SCSI hard
disk drives in the removable mass
storage cage (addresses = ID 0, 1,
2, 3).
Optional Tape Drive in shelf 3
(address = ID 4)
SCSI controller (address = ID 7)
Installing Mass Storage Devices
23
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
