HP D6030A - NetServer - E50 Installation Manual page 32
Hp netserver e 200 installation guide
Hide thumbs
Also See for D6030A - NetServer - E50:
- User manual (85 pages) ,
- Getting started (57 pages) ,
- Installation manual (46 pages)
Table of Contents
Advertisement
Chapter 4
9. Slide the drive into the cage opening with the cable connectors toward the
rear of the NetServer. See Figure 4-3.
Align the screw holes on the drive (or the shelf or brackets) with the screw
holes in the hard disk drive cage.
NOTE
If the hard disk drive you are planning to install already has a
mounting tray attached, you must remove it before you can
install the drive in your HP NetServer.
10. Install the screws to secure the drive (or the shelf or the brackets) to the
mass storage cage.
a. Attach one of the screws through the round screw hole at the rear of the
cage, then through the elongated hole at the front of the cage.
b. Repeat on the other side of the cage. See Figure 4-4.
26
Slots for tabs
Figure 4-3. Adding a Hard Disk Drive
Installing Mass Storage Devices
Captive Screw
Locations (3)
(one hidden)
Tabs
Insert screws through
round holes in back,
first. (Two screws each side)
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
