Hardware Security - HP D5970A - NetServer - LCII User Manual
Hp netserver lp 2000r (1.13, 1.26 & 1.40 ghz) user guide
Hide thumbs
Also See for D5970A - NetServer - LCII:
- Installation manual (203 pages) ,
- Installation and configuration manual (177 pages) ,
- Installation and user manual (174 pages)
Table of Contents
Advertisement
Chapter 10
2. Use the right-arrow or left-arrow key to select Security from the menu bar.
As soon as it is selected, the selections for the Security menu appear as
shown below.
➢Power-On Password
➢Hardware Security
The arrowhead ➢ indicates there is a submenu to select from.
3. If necessary, use the arrow key to move to the Power-On Password menu
selection and press Enter.
The Power-On Password is highlighted by default when the Security menu is
selected.
The first line in the menu is, "Power-on password is [Set or Not Set]"
a. If no password has been set, then "Not Set" will appear in the field. If this
is the case, then you can boot the Netserver without a password.
The Power-on password controls access to the Setup Utility and its
settings, but will not be in effect until you reboot the Netserver.
b. If "Set" is in the field, then you can change the password or remove the
password, if you know the existing password. If you do not know the
existing password, then refer to "Resetting a Lost Password" in Chapter
12, "Troubleshooting."
NOTE
You must set the Power-on Password to configure the HP
Netserver to boot with a password.
4. Press the Enter key to enter a new password or change the old one.
A pop-up menu appears titled, "Set Power-On Password." If no password has
been entered, the field "Enter new password: [
previous password has been entered, the field "Enter old password:
[
]" is highlighted.
NOTE
To leave the pop-up menu without entering a password, press
the Esc key at any time.
100
Configuring the HP Netserver
]" is highlighted. If a
Advertisement
Table of Contents
Troubleshooting
