Stackable NWay Ethernet Switch User's Guide
Configure Switch Stack
The Switch Stack Configuration screen shows various pieces of information about your Switch, and allows
you to set the System Name, System Location, and System Contact. These settings can be retrieved from the
Switch using SNMP requests, allowing these settings to be used for network management purposes.
Choose Configure Switch Stack to access the second item on the System Configuration menu. The
following screen appears:
The fields you can set are:
♦ System Name Corresponds to the SNMP MIB II variable
name to the Switch for administrative purposes. The Switch's fully qualified domain name is often
used, provided a name has been assigned.
♦ System Location Corresponds to the SNMP MIB II variable
indicate the physical location of the Switch for administrative purposes.
♦ System Contact Corresponds to the SNMP MIB II variable
name and contact information for the person responsible for administering the Switch.
Information of Individual Switch Unit
This screen allows you to view information for each Switch in your stack, including the Module, Type, and
Hardware Version. Press Information of Individual Switch Unit on the Switch Stack Configuration screen
to access the Information of Individual Switch Unit screen:
Using the Console Interface
Figure 6-11. Switch Stack Configuration screen
, and is used to give a
system.sysName
system.sysLocation
, and is used to give the
sysContact
, and is used to
53