Table of Contents
Advertisement
Listening to Radio Broadcasts
Manual tuner operation
1
Press BAND to select FM or MW or LW.
Each time you press BAND, "FM", "MW", "LW" will be
displayed in order.
STEREO
FM
5sv>vc«
QUART2L0CK
O i i r n
u u. u u
"Hl
2
Press one of TUNING to tune in to the desired
broadcast.
The display will show the frequency in which you have tuned.
• If you have tuned in an FM stereo broadcast, the FM stereo
indicator will appear.
• If you can't receive the desired broadcast or can't tune in the
desired frequency in the MW broadcast, you may need to
change the "allocation" setting. (See right.)
■ If noise is excessive in the FM mode
(Only from the remote control)
Press FM MODE.
■ MW allocation settings
This unit comes equipped with an electronic digital tuner that di¬
vides the broadcast band into many small steps. These steps match
the assignable broadcast frequencies and intervals in between.
Each country allocates (assigns) broadcast bands according to their
particular needs.
By adjusting the allocation, you can enable this tuner to receive MW
broadcasts allocated in 9 kHz steps.
1. Press BAND to select MW.
2. Press and hold BAND for approximately 3 seconds.
To return to the original frequency indication, repeat steps 1 to 2
above.
riov>VCW
VOLUME
MONO —
QUARTZLOCK
FM
i 11 i r n
U U. O U UH!
R
=IW
BALANCE
Lights
The sound will then be heard in monaural. If the broadcast signal is
weak, or if there is a large amount of interference, you will get a
clearer sound using FM MODE.
26
Advertisement
Table of Contents
