Table of Contents
Advertisement
en Wireless cooking sensor
Result
Connected
cookingSensor is available.
correctly
Not con-
Communication error
nected cor-
¡ Repeat the connection process.
rectly
If the result is still , contact
customer service.
Not con-
Communication error
nected cor-
¡ Bluetooth communication error.
rectly
Repeat the connection process.
¡ You have not touched the
centre of the wireless cooking
sensor within 30 seconds of se-
lecting the cooking zone. Re-
peat the connection process.
¡ The battery in the wireless
cooking sensor is flat. Replace
the battery, reset the wireless
cooking sensor and repeat the
connection process.
Resetting the wireless cooking sensor
Press the centre of the cooking sensor for approx. 8
1.
- 10 seconds.
Wireless cooking sensor
17 Wireless cooking sensor
To use cookingSensor, you must purchase a wireless
cooking sensor.
You can purchase the wireless cooking sensor from
customer service, in our online shop or in a specialist
shop siemens-home.bsh-group.com.
17.1 Scope of delivery
After unpacking all of the parts, check for any transport
damage and for completeness of delivery.
Wireless cooking sensor
¡
Silicone patch
¡
Template
¡
17.2 Attaching the silicone patch
The silicone patch secures the cooking sensor to the
cookware. For fitting on the cookware:
The adhesive area on the cookware must be free
1.
from grease. Clean and dry the container thor-
oughly, and rub the adhesive area using alcohol, for
example.
18
a During this process, the LED display for the wireless
cooking sensor lights up three times.
a When the LED lights up for the third time, it will start
to reset the temperature sensor.
Now stop pressing the centre of the wireless cook-
2.
ing sensor.
a As soon as the LED goes out, this means that the
wireless cooking sensor has been reset.
Repeat the connection process from point 2.
3.
Setting the boiling point
The point at which water starts to boil depends on the
height of your home above sea level. If the water is
boiling too vigorously or not vigorously enough, you
can adjust the boiling point. Proceed as follows:
Select the "Set boiling point" setting in
→ "Basic settings", Page 21.
The default basic setting is 200–400 m. If the home is
located at this height above sea level, do not set the
boiling point. Select the setting that matches your
home's height above sea level.
Note: The temperature 3/100 ºC is sufficient to boil ef-
ficiently. For a more intensive boil, select a lower level.
Remove the protective film from the silicone patch.
2.
Adhere the silicone patch to the outside of the cook-
ware in the correct place using the enclosed tem-
plate as a guide.
3.
Press down all over the surface of the silicone
patch, including in the centre.
Leave the adhesive to dry for one hour. Do not use
4.
or rinse out the cookware during this time.
Note: If the silicone patch comes loose, use a new
one. If required, you can purchase a set with five silic-
one patches from specialist retailers, from our cus-
tomer service or on our official website siemens-
home.bsh-group.com by quoting the article number
17007119.
All adhesives break down over time when they are
stored. To prevent this from happening, place the silic-
one bases on their containers as soon as they are
cleaned.
17.3 Attaching the wireless cooking sensor
Ensure that the silicone patch is completely dry be-
1.
fore attaching the cooking sensor.
Advertisement
Table of Contents
