Table of Contents
Advertisement
Introduction for buttons on remote controller
Note:
●
This is a general use remote controller, it could be used for the air conditioners
with multifunction; For some function, which the model doesn't have, if press
the corresponding button on the remote controller that the unit will keep the
original running status.
●
When power is connected (stand by condition), you can operate the air conditioner
through the remote controller.
● When unit is on, each time you press the button on remote controller, the sending
signal icon "
conditioner gives out a beep sound, it means the signal has been sent.
● When unit is off, set temperature will be displayed on the remote controller (If the
light of the unit display is turned on, the corresponding icon will be displayed);
When unit is on, it will display the icon of the on-going function.
1
ON/OFF button
Press this button to turn unit on/off.
2
MODE button
Pressing this button once can select your required mode circularly as below (the
corresponding icon "
● When selecting auto mode, air conditioner will operate automatically according to
ambient temperature. Set temperature can't be adjusted and won't be displayed
either. Press FAN button to adjust fan speed.
●
When selecting cool mode, air conditioner will operate under cool mode. Then
press + or - button to adjust set temperature. Press FAN button to adjust fan speed.
●
When selecting dry mode, air conditioner will operate at low fan speed under dry
mode. In dry mode, fan speed can't be adjusted.
●
When selecting fan mode, air conditioner will operate in fan mode only. Then
press FAN button to adjust fan speed.
●
When selecting heat mode, air conditioner will operate under heat mode. Then
press + or - button to adjust set temperature. Press FAN button to adjust fan speed.
(Cooling only unit can't receive heating mode signal. If set HEAT mode by remote
controller, press ON/OFF button can't turn on the air conditioner.)
3
+ / - button
●
Pressing + or - button once will increase or decrease set temperature by 1°F(°C).
Hold + or - button for 2s, set temperature on remote controller will change quickly.
Release the button after your required set temperature is reached.
●
When setting Timer On or Timer Off, press + or - button to adjust the time. (See
TIMER Button for setting details)
" on the display of remote controller will blink once. If the air
" will be lit up after the mode is selected):
AUTO
COOL
DRY
FAN
HEAT
- 17 -
Advertisement
Chapters
Table of Contents
