(7) OPTION
• OUTPUT1
RGB, Y/PR/PB
• OUTPUT2
VBS, Y/C
• SHADING MODE
SET, MANUAL, OFF
• Manual shading setting
-128 to 127
• RGB SYNC
G, ALL ON, ALL OFF
• Freeze display
ON, OFF
• Nega/Posi inversion SW
NEGA, POSI
• Detail signal output
ON, OFF
• RS232C baud rate
9600bps, 19200bps
(7. 1) Changing OUTPUT1 output
® Set the
" to OUTPUT1 by pushing [MENU UP], [MENU DOWN] buttons.
(D Select either RGB or Y/PR/PB by pushing [DATA UP], [DATA DOWN] buttons.
(7. 2) Changing OUTPUT2 output
0 Set the
" to OUTPUT2 by pushing [MENU UP], [MENU DOWN] buttons.
(D Select either VBS or Y/C by pushing [DATA UP], [DATA DOWN] buttons.
(7. 3) Changing shading correction mode
® Set the
" to SHADING by pushing [MENU UP], [MENU DOWN] buttons.
(D Select SET, MANUAL or OFF by pushing [DATA UP], [DATA DOWN] buttons.
(7. 4) Changing manual shading correction mode
(D Set the
" to MANUAL by pushing [MENU UP], [MENU DOWN] buttons.
(D Set manual shading correction by pushing [DATA UP], [DATA DOWN] buttons.
[DATA UP] -►
-127^-► 0
-► 128
◄-[DATA DOWN]
* When the shading correction mode is set to anything other than MANUAL, the display turns off, so
the setting cannot be made.
(7. 5) Changing RGB SYNC
® Set the
to RGB SYNC by pushing [MENU UP], [MENU DOWN] buttons.
(D Select G, ALL ON or ALL OFF by pushing [DATA UP], [DATA DOWN] buttons.
* When Y/PR/PB is selected at OUTPUT1, the display RGB SYNC turns off automatically. So RGB
SYNC change cannot be performed.
37