Table of Contents
Advertisement
2.1 Installation to Primaide 1000 Series Unit
2. INSTALLATION
AID is installable into the back of each unit of Primaide 1000
series (except for an organizer, autosampler and FL Detector).
After attaching AID to the back of a unit, connect the e-Line
connector (upper) that supplies 5 V for the unit and the e-Line
connector of AID by using the attached e-Line cable.
Back of unit
AID
Fig. 2-1 Attaching AID
NOTE:
Make sure to connect the e-Line of AID with the e-
Line of the 5 V supply side of the unit in which AID is
installed. Unless connected correctly, power will
not be supplied to AID and it will not operate
properly.
2 - 1
e-Line connector
(AID)
e-Line connector
(supplies 5 V)
Unit
(Primaide
1000series)
2.1
Advertisement
Table of Contents
