Sending The Dtmf Code Configured For Eot - Kenwood NEXEDGE NX-200 Function Reference

Hide thumbs Also See for NEXEDGE NX-200:

Table of Contents

14.1 Method of Sending the DTMF Code

Sending the DTMF Code Configured for EOT

The DTMF code configured for End of Transmit can be sent.

This function is unavailable for NX-200S/ NX-300S.

Operating the Transceiver

The transceiver enters Autodial Mode.

key and then the

The DTMF code configured for End of Transmit appears.

To cancel the operation, the Side 1 (NX-200/ NX-210/ NX-300/

NX-410/ NX-411) or the Triangle key (Mobile) needs to be

Select one of the following operations.

• To send the DTMF code and initiate voice calls, the PTT switch

needs to be pressed.

• To send only the DTMF code, the Side 2 key (NX-200/ NX-210/

NX-300/ NX-410/ NX-411) or the Square key (Mobile) needs to

The transceiver sends the DTMF code.

Configuration using KPG-111D/ DN

Configuring the End of Transmit (

FUNC (K)/Ver 4.00

key while the transceiver is in standby mode.

FPRG 8.10.6 Common Page 4 Tab)

Table of Contents