Installing Ac Power; Installing Dc Power - Motorola L6Q Installation Manual
Hide thumbs
Also See for L6Q:
- Installation manual (257 pages) ,
- User manual (193 pages) ,
- Get started manual (36 pages)
Table of Contents
Advertisement
3.3
Installing AC Power
The AC 120V External Power option requires an existing AC power outlet installed by a certified
electrician. Mounting of the 120V AC Power Adapter and cable management is dependent on the
camera mounting location and distance to the power source.
Prerequisites: Obtain:
•
120V AC Power Adapter
•
Zip-Tie (1x)
Procedure:
1 Plug the 120V AC Power Adapter into a furnished AC power outlet.
2 Check the power cable length.
a Run the AC adapter power cable to the approximate location of the camera.
b Use a Zip-Tie to secure the end of the cable in place.
3 Go to
Camera
Installation.
3.4
Installing DC Power
The 12V DC External Power option requires an existing DC power facility installed by a certified
electrician. It is necessary to splice together the wires of the power source and the DC Power Cable.
Cable management is dependent on the camera mounting location and distance to the power source.
Prerequisites: Obtain:
•
12V DC Power Cable
•
Wire Snips
•
Wire Shrink Wrap or Electrical Tape
Procedure:
1 Splice the conductors from the DC power source to the conductors of the 12V DC Power Cable.
a Use the Wire Snips to strip the ends of each conductor.
Strip off one-half to one inch of insulation as necessary.
b Optional: Slip a section of Wire Shrink Wrap over each conductor.
c Use solder, wire twisting caps, or securely twist to splice the conductors.
Splice the positive (PV+) DC power cable conductor to the positive (PV+) power source
conductor. Splice the negative (PV-) DC power cable conductor to the negative (PV-) power
source conductor.
d Securely insulate the splices with the Wire Shrink Wrap or Electrical Tape.
MN010089A01-AB
Chapter 3 : Hardware Installation
51
Advertisement
Table of Contents
