Bosch AUTODOME 7100i User Manual page 72
Hide thumbs
Also See for AUTODOME 7100i:
- Installation manual (52 pages) ,
- Installation manual (84 pages)
Table of Contents
Advertisement
72
en | Status codes
Status
Code
18**
19**
20
23
25
2022-12 | V01 | DOC
Description
When operating using redundant
power sources, the camera has
detected a loss of power from the
external 24 VAC power source.
When operating using redundant
power sources, the camera has
detected a loss of power from the
external High PoE power source.
Camera is configured to use the
"Hard Pan Limits" (HPL) feature
and power was applied with the
pan position in the forbidden
zone.
An internal error has occurred.
(The optical video screen
becomes blue for 1 or 2 seconds
during the camera's recovery
procedure).
When operating using redundant
power sources, the camera has
detected a loss of power from the
external 36 VDC power source.
User Manual
Recommended action
(to be completed by a qualified Service
Technician)
3. If operation is obstructed because of
excessive ice buildup, temporarily avoid
operating the pan/tilt functions of the camera
until internal heaters, combined with a rise in
ambient temperature, melt the ice buildup.
1. Verify the operating status of the external
24 VAC power source.
2. Verify the integrity of the electrical
connections between the power source and
the camera.
1. Verify the operating status of the external
High PoE power source.
2. Verify the integrity of the electrical
connections between the power source and
the camera.
Temporarily remove one of the hard pan
limits (as described in PTZ Settings), pan the
camera out of the forbidden zone, and then
restore the hard pan limit.
Reboot the camera by powering the camera
off and then on, or by clicking the button
Reboot in the camera's web browser
(Configuration > Camera > Installer Menu
>Reboot device).
Note: If pan movement is blocked only in one
direction, but possible in the other direction
(as when the camera is near the HPL), then
no status code appears.
If this problem begins to occur on a regular
basis:
1. Verify that the power source to the camera
is not experiencing brown-out conditions.
2. Verify that the camera's earth ground
connection is attached per earlier
instructions.
If these actions do not resolve this problem,
contact the nearest Bosch Security Systems
Service Center.
1. Verify the operating status of the external
36 VDC power source.
2. Verify the integrity of the electrical
connections between the power source and
the camera.
Bosch Security Systems B.V.
AUTODOME 7100i
- Quick Links:
- Browser Connection
- Network
Hide quick links:
Advertisement
Table of Contents
