Table of Contents
Advertisement
NOTE: Depending on the order, the shipment can include
NOTE: The customer must arrange equipment for transport-
5322 871 63303
96.00
General Requirements
General
2.3 Accessibility of Selected Site
The system is shipped in one crate (see note below).
The dimensions of the CSM III crate are as follows:
Height
Width
Depth
Gross weight approximately
(max. size crate with contents)
The dimensions of the optional CSM trayfeeder 31 crate are as follows:
Height
Width
Depth
Gross weight approximately
(crate with contents)
additional crate(s), which contain a number of smaller
items, such as CSM trayfeeder, tape feeders, etc.
The dimensions of these crates depend on the num-
ber and size of the ordered items, but will always be
smaller than the above-mentioned crate.
The equipment should be unpacked as close to the final site as possible.
Access doors must have minimum dimensions of 1810 mm height and 1600
mm width (the dimensions are larger than the actual sizes to allow room to
manoeuvre).
2.3.1 Transport
The dimensions of the uncrated CSM III system are as follows:
Width
Height, without signal pole and monitors
Height, with signal pole (max. height)
Depth, without feeders
Ensure that adequate access is provided to move this system to its final
location.
ing the system. Depending on the local circum-
stances, the following equipment may be required:
fork lift truck: lifting capacity 2500 kg; fork length > 1400 mm,
sheet steel to protect the floor,
two pallet cars,
trolleys,
winches,
two wooden beams 2000 cm long, 100 x 100 cm square.
Pre-installation Manual CSM 66/84/84V III
PA 1306/40 /50 /60 /61
Requirements
1610 mm
1400 mm
1700 mm
640-775kg
1370 mm
1290 mm
1270 mm
230 kg
1600 mm
1330 mm
1840 mm
1140 mm
5
Advertisement
Table of Contents
