Table of Contents
Advertisement
STEERING / SUSPENSION
UPPER STEERING SHAFT INSTALLATION
NOTE
If steering wheel was removed, follow this procedure to
ensure the upper steering shaft is properly positioned
on the power steering stub shaft.
CAUTION
Striking the steering wheel or steering shaft can
permanently damage the EPS unit and cause a Power
Steering Fault.
1. Install the upper steering shaft and align the skip-
q
tooth spline
on the power steering stub shaft with
w
the opening
in the upper steering shaft.
2. Install the pivot tube and torque fasteners to
specification.
TORQUE
Pivot Tube Fasteners:
40 ft-lb (54 Nm)
3. Install the tilt shock and torque fastener to
specification.
TORQUE
Tilt Shock Fastener:
7 ft-lb (10 Nm)
4. Be sure the front wheels are pointing straight ahead
and install the steering wheel and retaining nut.
Torque the nut to specification and reinstall the plastic
wheel cover.
TORQUE
Steering Wheel Nut:
65 ft-lbs (88 Nm)
9926814 R08 -
8.14
5. Install a new upper steering shaft pinch bolt and nut.
Torque pinch bolt to specification.
Upper Steering Shaft Pinch Bolt:
6. Reconnect both electrical harnesses onto the power
steering unit. Be sure the connectors snap into place.
7. Reinstall the black plastic cover over the power
steering unit and install the two Torx fasteners.
8. Turn the key switch on and test EPS operation.
2015-2016 RZR 900
TORQUE
15 ft-lbs (20 Nm)
2016 RZR S 1000 Service
© Copyright Polaris Industries Inc.
Manual
Advertisement
Chapters
Table of Contents
Troubleshooting
