Table of Contents
Advertisement
STEERING / SUSPENSION
5. Torque
the
four
specification.
TORQUE
Power Steering Unit Mount Bracket Nuts:
18 ft-lb (24 Nm)
6. Proceed to Upper Steering Shaft Installation page
7. Vehicles equipped with Dynamix suspension having a
steering shaft, EPS unit, steering rack, or tie rod
removed/adjusted/disconnected MUST have Steering
Angle Sensor Centering procedure performed once
everything is reinstalled. Refer to Steering Angle
Sensor Centering (Dynamix) page 12.18.
8.18
mount
bracket
nuts
y
UPPER STEERING SHAFT INSTALLATION
to
If steering wheel was removed, follow this procedure to
ensure the upper steering shaft is properly positioned
on the power steering stub shaft.
Striking the steering wheel or steering shaft while
installed in the vehicle can permanently damage the
EPS unit and cause a Power Steering Fault.
Be sure upper steering shaft hardware is positioned
1. Install the upper steering shaft and align the skip-
tooth spline
the opening
.
2. Install the steering column asm and torque fasteners
to specification.
Steering Column Asm Fasteners:
3. Install the tilt shock and torque fastener to
specification.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
NOTE
CAUTION
NOTE
correctly.
q
on the power steering stub shaft with
w
in the upper steering shaft.
TORQUE
40 ft-lb (54 Nm)
TORQUE
Tilt Shock Fastener:
7 ft-lb (10 Nm)
© Copyright Polaris Industries Inc.
Advertisement
Chapters
Table of Contents
Troubleshooting
