Table of Contents
Advertisement
Parking Brake Lever Removal and Installation
CAUTION
!
For ESP model, the yaw rate / G sensor is set
alongside the parking brake lever. When
removing and installing the parking brake
lever, do not use an impact wrench.
Otherwise, the yaw late / G sensor may be
damaged by shock of impact wrench.
Removal
1) Block vehicle wheels and release parking brake
lever.
2) Remove console box.
3) Disconnect lead wire of parking brake switch at
coupler.
4) Remove parking brake cable adjusting nut (1).
2. Brake cable
5) Remove parking brake lever bolts (4) and then
remove parking brake lever assembly (1) from
equalizer (3).
6) Remove equalizer (3) from parking brake cable (2).
NOTE
Don't disassemble parking brake lever
switch. It must be removed and installed as a
complete switch assembly.
5. Pin
S6JB0A4406002
1
2
I5JB0A430002-02
I5JB0A440004-01
Installation
Install in reverse order of removal procedure, noting the
following points.
• Check equalizer inclined angle.
Equalizer inclined angle
"a": within 15 degrees
Tightening torque
Parking brake lever bolt (a): 25 N·m (2.5 kgf-m,
18.0 lb-ft)
1. Parking brake cable
2. Equalizer
3. Pin
1) After all parts are installed, parking brake lever
needs to be adjusted. Refer to "Parking Brake Check
and Adjustment".
2) Check brake drum for dragging and brake system for
proper performance. After removing vehicle from
hoist, brake test should be performed.
Parking Brake:
4D-3
I5JB0A440005-01
4. Parking brake lever bolt
5. Parking brake lever
Advertisement
Chapters
Table of Contents
