Table of Contents
Advertisement
● Code :
H1-1417
H1-1418
● Symptom / Cause :
Paper transport jam (paper Input section)
- The paper from the tray4 has not reached the tray4 fe
- When you open and close the take away (DCF, HCF
sensor.
● Troubleshooting method :
1. Open the side & take away door. Remove the jamm
1 O
th
id & t k
Close the Side door. After warm up, if same jam occ
2. Open the side & take away. Remove the jammed pa
and tray3 feed roller. If there is any defective part in
3. If the white idle roller of the take away door breaks a
roller.
4. Check if the wall connector of tray4 pick up
connector.
5. Enter the diagnostic mode, and check the feed sens
If th
If the paper is at sensor and "Without paper" messag
i
t
6. Check if the connector of the tray4 pick up unit on th
Reconnect it.
7. Replace the DCF board (JC81-08324A) or HCF boa
Service Manual
7. Troubles
● Error message :
Paper jam in tray 4
d
R
th j
y
unit(JC8
d "With
t
"
shooting
eed sensor within normal time.
) door, the paper has jammed at the tray4 feed
med paper.
d
curs, check the following.
aper between the feed roller of the tray4 pick up unit
n this area, replace it.
away, release the inner cover and reassemble the idle
y
81-07923A) is connected properly. Reconnect the
sor(0604-001393) test of the tray4 pick up unit.
ge is displayed, replace the sensor.
i di
l
d
l
he pick up drive unit is connected properly.
ard(JC81-07292A)
7-7
71
th
SAMSUNG ELECTRONICS
Advertisement
Table of Contents
