Installation Method - Panasonic LP-RF Series Setup & Maintenance Manual
Laser marker
Hide thumbs
Also See for LP-RF Series:
- Operation manual (358 pages) ,
- Serial communication command manual (208 pages) ,
- Quick reference (46 pages)
Table of Contents
Advertisement
2-3-2 Installation method
• Install the head on a plate with a thickness of 10 mm to 20 mm which is made of aluminum or other material with
radiation performance equivalent to that of aluminum.
• For details of installation, refer to "1-4-1 Head" (P.25).
• Fix the head in the following conditions.
Fixing surface
Bottom (laser emission port side)
M6 screw
Fix the bottom of head with M6 screw more than 6 positions as shown below.
Example of fixing positions
• Do not insert any screw of length exceeding the specification. Otherwise, the failure of
the product may be caused.
• A protection cap is installed on the laser emission port with shipment. Remove this
cap before operation. Do not screw the lens when removing the cap.
38
Fixing screw
M6 screws at more than 6 positions
Bottom of the head
ME-LPRF-SM-11
Screw insert length
5 mm to 6 mm
Laser marker head
Installation plate
A : Screw insert length 5mm to 6mm
B : Plate thickness + washer thickness
Tightening torque
3.0 N·m or below
A
B
M6 screw
Advertisement
Table of Contents
Troubleshooting
