Set The Laser Marker Communication Settings - Panasonic LP-RF Series Setup & Maintenance Manual
Laser marker
Hide thumbs
Also See for LP-RF Series:
- Operation manual (358 pages) ,
- Serial communication command manual (208 pages) ,
- Quick reference (46 pages)
Table of Contents
Advertisement
6-1-4 Set the laser marker communication settings
1.
Establish an online connection between your PC and the laser marking system.
2.
Go to the "System settings" screen and select "Communication" tab.
3.
Set the Ethernet communication configuration of the
laser marker.
4.
Open the "Linked device" tab and configure the
communication settings of the imagechecker according
to the functions to use.
For image checking before marking:
• IP Address
For image checking after marking:
• Model of image checker: PV230/PV200, DataMan,
LP-ABR
• IP Address
• Port (for LP-ABR and DataMan)
• Specify these values according to communication settings of the image checker to connect.
• The Port number for PV230/PV200 is a fixed value.
• Specify Telnet Port for DataMan port number.
• For LP-ABR, set the port number with the same value of "Data Port No" in Configurator LP-ABR.
5.
Select "Apply to laser marking system" on the left side of the ribbon.
6.
Disconnect the online connection with the laser marker.
7.
Turn off the power of the laser marking system, wait five seconds and then restart the system.
The configured items will be reflected to the laser marker.
140
ME-LPRF-SM-11
"Apply to laser marking
system" tool
Advertisement
Table of Contents
Troubleshooting
