Panasonic LP-RF Series Setup & Maintenance Manual page 204
Laser marker
Hide thumbs
Also See for LP-RF Series:
- Operation manual (358 pages) ,
- Serial communication command manual (208 pages) ,
- Quick reference (46 pages)
Table of Contents
Advertisement
ERROR
CODE
• The date and time of the system clock may be
out of synchronization.
• The system clock battery power in the
E450 - E453
controller died.
• Abnormality has occurred on the system clock
in the controller.
E460 *2
Temperature error in laser oscillator.
E505 - E509
Safety functions (INTERLOCK, LASER STOP,
E550 - E560
etc.) were activated during marking preparation.
E572
E520 - E522
E570
File data or system data were not saved
successfully, because the laser marker was
turned off while saving data.
Unable to read the file data.
E530 - E542
E571
*1 : If the error persists after restart of the laser marker, contact our sales office or representatives.
*2 : Error that may occur for LP-GS series only.
*3 : Error that may occur for LP-RC series only.
*4 : Error that may occur for LP-RF series and LP-RV series only.
204
Description
ME-LPRF-SM-11
Measures *1
• Check the system clock time and set it again.
• Replace the internal battery by following the
"Replacement of Internal Controller Battery" in
the "Setup/Maintenance Guide".
• While laser marker power is on, you can use
it after setting the system clock on the system
settings screen. When the power is off, set the
system clock again.
• Check if the ambient temperature of the
laser marker is not exceeding the range of its
specification.
• Make sure air-cooling fan operates.
• Remove the dust and contamination in the
air intake and exhaust port, and clean the air-
cooling part such as fan and filter.
• When not recovered, contact our sales office
or representatives.
• Reset the alarm for LASER STOP IN or
INTERLOCK of the I/O terminal block or Stop
laser button of Laser Marker NAVI smart
software.
• Check if the signal lines are effected by noise.
• Overwrite the data again to the selected file
number.
• Do not turn off the laser marker while saving
the settings.
• Restore the backup file saved before to the
laser marker.
• Do not turn off the laser marker while saving
the settings.
Advertisement
Table of Contents
Troubleshooting
