Canon Pro9000 Mark II Service Manual page 16
Hide thumbs
Also See for Pro9000 Mark II:
- Quick start manual (215 pages) ,
- Release note (4 pages) ,
- Setup instructions (2 pages)
Advertisement
14 times Ink tank not
recognized.
15 times Ink tank not
recognized.
16 times No ink (no raw
ink).
19 times Non-supported
hub.
*1: Only for CD / DVD printing supported regions.
*2: Only for CD / DVD printing no-supported regions.
replacing the ink tank(s), press
the Resume/Cancel button for 5
sec. or longer to disable the
function to detect the
remaining ink amount. After
the operation, it is recorded in
the printer EEPROM that the
function to detect the
remaining ink amount was
disabled.
[1684] U140 A non-supported ink tank (an
ink tank that is sold in a
different region from where the
printer was purchased) is
installed (the ink tank LED is
turned off). Install the
supported ink tanks.
[1682] U150 A hardware error occurred in
an ink tank (the ink tank LED
is turned off). Replace the ink
tank(s).
[1688] U163 Replace the empty ink tank(s),.
Printing with an empty ink tank
can damage the printer.
To continue printing without
replacing the ink tank(s), press
the Resume/Cancel button for 5
sec. or longer to disable the
function to detect the
remaining ink amount. After
the operation, it is recorded in
the printer that the function to
detect the remaining ink
amount was disabled.
[2002] --- Remove the applicable USB
hub from the PictBridge (USB)
connector.
13 / 56
- Ink tank
- Logic board
- Carriage unit
- Ink tank
- Logic board
- Carriage unit
- Ink tank
- Logic board
- Carriage unit
- DSC harness
- Logic board
Advertisement
