Table of Contents
Advertisement
Cleaning and care
If the functions and automatic
programmes that use added moisture
are already locked, the descaling
process can be started immediately by
touching OK.
Push the universal tray into the top
shelf level as far as it will go to collect
the descaling solution after it has
been used. Confirm the message
shown with OK.
Place the container with the
descaling solution on the floor of the
oven compartment.
Attach one end of the plastic tube to
the water intake pipe. Place the other
end of the plastic tube in the bottom
of the descaling solution container
and secure the plastic tube to the
container with the suction cup.
Confirm with OK.
The water intake process will begin. You
will hear the noise of the pump.
You can interrupt and resume the
intake process at any time by
selecting OK.
70
The amount of solution specified may
exceed the amount which is actually
taken in. Some of the solution may
therefore be left in the container at the
end of descaling.
A message will appear to confirm that
the intake process is complete.
Confirm with OK.
The activation phase will begin. You
can watch the time counting down in
the display.
Leave the container in the oven with
the tube still connected to the water
intake pipe. Top the container up with
approx. 300 ml of water, as the
system will need to draw in some
more liquid during the activation
phase.
The system will take in more liquid at
approximately 5 minute intervals. You
will hear the noise of the pump.
The interior lighting and cooling fan
remain switched on for the whole
duration of the process.
At the end of the activation phase a
buzzer will sound.
Rinsing the steam injection system
after the activation phase
After the activation phase the steam
injection system must be rinsed out to
remove residues of descaling solution.
To do this approx. 1 litre of fresh tap
water is pumped through the steam
injection system three times and is
collected in the universal tray.
Advertisement
Table of Contents
