Please note:
Depending on the system
width and the installation
situation, it may be
necessary to remove the
rollers (See page 48) or
the HQ 5 from the section
for better accessibility.
Required tools
• Hex wrench SW8
1.
Remove the motor
(See page 45).
2.
Remove the snap ring on
the drive shaft.
3.
Pull the drive shaft off
the gear with the aid of
an M8 screw.
4.
Remove the adapter
piece and the protective
sleeve.
5.
Remove the gear.
Assembly is
correspondingly done in
the reverse order.
10.4.5
Replacing the gear on a standard motor
2x
SW8
M
=20 Nm
D
Fig. 25:
Replacing the gear on a standard motor
Maintenance and repair
4
5
3
3 842 558 544/2017-07, MIT: HQ 5/H, HQ 5/XH, Bosch Rexroth AG
47/60
2
5
3
557 617-25