Table of Contents
Advertisement
Installation
Revision B
Equipment Overview: Installation
:$51,1*6
CABLES — Route all cables away from patient's throat
to avoid possible strangulation and to prevent interfering
with the monitor's attachment to the docking station.
SITE REQUIREMENTS — For safety reasons, all
connectors for patient cables and sensor leads are
designed to prevent inadvertent disconnection, should
someone pull on them. Do not route cables in a way that
they may present a stumbling hazard. For devices
installed above the patient, adequate precautions must
be taken to prevent them from dropping on the patient.
&$87,216
PERSONAL INJURY HAZARD — To reduce the
potential for orthopedic injury, mount the docking station
at a height which prevents overextension of the user's
arms when connecting and disconnecting the monitor.
POWER REQUIREMENTS — Before connecting the
device to the power line, check that the voltage and
frequency ratings of the power line are the same as those
indicated on the unit's label. If this is not the case, do not
connect the system to the power line until you adjust the
unit to match the power source.
In U.S.A., if the installation of this equipment will use
240V rather than 120V, the source must be a center-
tapped, 240V, single-phase circuit.
127(
The docking station has a standard GCX mounting plate for quick
mount/dismount access to GCX mounting devices.
Complete the following to install the docking station.
1. Ensure the wall receptacle is wired correctly.
2. Slide the docking station onto the mounting device's GCX plate.
Verify it is secure.
3. Connect the AC power cable to the docking station and to an
appropriate AC power source.
4. Insert the Unity MC-Network connector into the ETHERNET port
of the docking station.
5. Complete the
"Electrical Safety Tests"
Procedures"
on page 3-17.
Dash Port Docking Station
2000966-037
on page 3-6 and the
"Checkout
2-5
Advertisement
Table of Contents
