Table of Contents
Advertisement
How to Install
How to Install
This section described how to install and configure an additional Site Controller, gaining
Redundant Site Controller functionality.
Process 8-6 Adding Redundant Site CONTROLLER
1
2
3
4
5
8-44
You must be familiar with Man-Machine Interface (MMI) commands and their
usage prior to performing procedures in this chapter. Improperly applying
MMI commands can result in equipment damage.
You must disable Black Ice or any other Firewall application before attempting to transfer files.
The MTS Site Controller has the following modes of operation:
• BOOT1 - to access this mode interrupt the booting process by pressing Escape
key or Control+C combination when appropriate message is shown. A
password may be required to enter this mode.
• Test Application - to access this mode enter the testapp command when in BOOT1
mode. To go back to normal Site Controller Application enter reset -oplatform
command to reboot and resume normal operation.
• Site Controller Application - if the boot process is not interrupted, this
is the default mode of operation.
When adding an additional (redundant) Site Controller there will be some service
downtime while making physical modifications.
Back up the Site Controller configuration of the existing Site Controller, See
- Configuration Backup," on page
This assumes that the existing Site Controller is properly configured and in service.
Add second Site Controller, see
page 8-45
below.
Restore the Site Controller Software on the second Site Controller, see
Restoring the Site Controller Software," on page
Configure E1 Links on the second Site Controller, see
E1 Links," on page
8-29.
Configure CAN Bus on the second Site Controller,
CAN Bus," on page
8-33.
8-19.
Procedure 8-25, "Add Additional Site CONTROLLER," on
8-23.
Procedure 8-12, "MTS - How to Configure
seeProcedure 8-13, "MTS - How to Configure
Chapter 8: Site Controller
Process 8-2, "MTS
Process 8-3, "MTS -
6802800U74-N September 2009
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
