Table of Contents
Advertisement
After you slide the ADP module into both carrier slots, first secure the two bottom screws,
and then secure the two top screws. Ensure that both of the ejector and locking levers are
fully secured.
After you physically install the ADP module, reboot the system and reconfigure the
interfaces as described in
on page 71.
The following figure shows an IP1220 and IP1260 ADP module and card carrier assembly.
Link and Activity LEDs
To install or remove ADP transceivers in a Nokia ADP module
Refer to the following figure, which shows how to install or remove Nokia ADP module
transceivers. The transceivers are hot swappable as are the interface cables you use with them.
Rotate the latch levers up or down to secure transceivers, or to release them for removal. You do
not need to change the interface type in Network Voyager or the CLI, as the system makes the
configuration changes automatically.
To identify whether a fiber transceiver you are using is short-range or long-range, refer to the
color of the latch lever as follows:
IP1220 and IP1260 Security Platforms Installation Guide
All manuals and user guides at all-guides.com
"Configuring Nokia IPSO for IP1220 and IP1260 ADP Interfaces"
ADP Card
Installing and Replacing ADP Modules
Power LED illuminates green when
the module is under power
1
5
2
6
3
7
4
8
Ejector and locking levers
POWER
00651
69
Advertisement
Table of Contents
