Configuration And Operation - Bosch DCN Next Generation Installation And User Instructions Manual
Digital congress network
Hide thumbs
Also See for DCN Next Generation:
- Installation and operation manual (286 pages) ,
- Operation manual (290 pages) ,
- Installation & user's instructions (288 pages)
Table of Contents
Advertisement
DCN NG | Installation and User Instructions | Section 3 | Central Control Equipment
To navigate through the main menu:
1 Turn the button to move through the main menu
items. The item number and title start blinking.
(The first item, Main, does not blink.)
To jump to a submenu:
1 Navigate in the main menu to an item with three
dots (e.g. Setup ...).
2 Push the button to go to the submenu. The submenu
item and title start blinking.
Note
To enter the Setup submenu, push and hold the
button for at least 3 seconds.
To navigate through a submenu:
1 Turn the button to move the cursor to the submenu
item character.
2 Push the button. The item character and title start
blinking.
3 Turn to select another submenu item character.
4 Push to confirm the selection.
To change option values:
1 Navigate to the applicable menu item.
2 Turn the button to move the cursor to the option
value you want to change.
3 Push the button to activate the option. The option
value starts to blink.
4 Turn the button to select a new option value.
5 Push the button to confirm the new value. The
option value stops blinking.
6 Turn the button to move the cursor to another
settable option (when available) and repeat
steps 3 to 5.
To jump back from a submenu to an item of
the main menu:
1 Turn the button to move the cursor to the main
menu item number.
2 Push the button. The item number starts blinking.
3 Turn to select another item number.
4 Push to confirm the selection.
Bosch Security Systems | 2004-03 | 9922 141 70521en
10.6
Configuration and operation
10.6.1 Introduction
The next sections give descriptions of the possible
configuration options. Each description is followed by
the relevant menu items with detailed information per
menu option. The default values are indicated by an
asterisk (*) when applicable.
10.6.2 Start-up
When the analogue audio expander is activated, the
display shows the Main screen, which is the first item of
the main menu. The display also goes to this screen
after 3 minutes of inactivity.
Note
The audio expander does not switch back to the
start-up screen after 3 minutes of inactivity in
submenu 2.
10.6.3 Main menu
The main menu contains the screens to show the unit
name and contains the entry points to the Monitoring,
Enquiry and Setup submenus.
table 10.8: Main menus
Menu
Description
0 Main
Shows the main screen. See
section 10.6.4.
1 Fault Status
Go to the Fault Status submenu.
See section 10.6.5.
2 Monitoring
Go to the Monitoring submenu.
See section 10.6.6.
3 Enquiry
Go to the Enquiry submenu. See
section 10.6.7.
4 Setup
Go to the Setup submenu. See
section 10.6.8 (and further).
10.6.4 Main screen
The first screen of the main menu shows the name of
the analogue audio expander and the input and output
activities. The default name is Analog Expander.
en | 88
- Quick Links:
- Programming
Hide quick links:
Advertisement
Table of Contents
