Table of Contents
Advertisement
Output Terminal 1 (OUT1) Function
OUT1
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT1 dis-
crete output terminals O1A and O1B.
The O1A and O1B (OUT1) output terminals change states (open
or close) as a function of a user-selected event. See
page 257
terminals.
In addition, the output terminals must be specified as Normally
Open or Normally Closed.
Output Terminal 2 (OUT2) Function
OUT2
Program Terminal Output Terminals
This parameter is used to set the functionality of the OUT2 dis-
crete output terminals O2A and O2B.
The O2A and O2B (OUT2) output terminals change states (open
or close) as a function of a user-selected event. See
page 257
terminals.
In addition, the output terminals must be specified as Normally
Open or Normally Closed.
Output Terminal 3 (FL) Function
Program Terminal Output Terminals
This parameter is used to set the functionality of the FL output
terminals to one of the user-selectable functions listed in
on page
In addition, the output terminals must be specified as Normally
Open or Normally Closed.
https://www.toshiba.com/tic/
Direct Access Parameter Information
Q9 Plus ASD Install/Op Manual
for a listing of the possible assignments for the OUT1
for a listing of the possible assignments for the OUT2
257.
–
F130
F133
Direct Access Number —
Parameter Type — Selection List
Factory Default — Damper Com-
mand
Changeable During Run — No
Table 12 on
Direct Access Number —
Parameter Type — Selection List
Factory Default — Acceleration/
Deceleration Completion
Changeable During Run — No
Table 12 on
Direct Access Number —
Parameter Type — Selection List
Factory Default — Failure FL (All
Trips)
Table 12
Changeable During Run — No
F130
F131
F132
93
Advertisement
Table of Contents
