GE LOGIQ E9 Service Manual page 405

Hide thumbs Also See for LOGIQ E9:

Table of Contents

5573152-100, R

The R5 and later Arm Assembly Cable

route in the same manner as R4.

R5 has a has a ground Cable for the Arm.

R6 and later has no ground Cable for the

Take the Monitor Arm and Cables and feed

the Power Cable into the Adapter first.

Position the Video Cable Connector as

shown and continue to feed the cables into

the Adapter.

Install the Arm Assembly.

R6 and later:

Route the Cables into the Adapter one at a

Position the Arm Assembly so the Set

Screw mounting hole faces the left side of

the LOGIQ E9.

Install the Set Screw. Torque: 9.8 Nm

(7.2 lbf-ft {86.4 lbf-in}).

Monitor Arm assembly (Ergotron) installation - R5 and later production

Chapter 8 Replacement procedures

Corresponding Graphic