Table of Contents
Advertisement
IndraControl VAC 08.1 CDI+ Splitter
Digital input MOD
A PLC usually controls this input. Wire the respective PLC output with input
"MOD" on the CDI+ splitter.
10.5.5 Connecting the CDI+ interface of the CDI+ splitter to the opera-
tor display
Connect either the XCDI+tx1 connection or the XCDI+tx2 connection to the XCDI
+rx connection of the operator display using an Ethernet cable. Use the cables
listed in
tab. 5-4 "CDI+ connecting cable" on page
Cable lengths
The connecting cable is available in different lengths.
Use only cables listed in
+ interface" on page
Malfunctions if the CDI+ cable lengths exceeds 100 m.
10.5.6 Connecting the USB interface to the PC
Connect the "XUSB" connection to a USB port of the PC using a USB cable. The
maximum cable length is 3 m. Use this connection to set up the USB connection
between the operator display and the PC.
10.5.7 Connecting the image interface to the PC
Connect the "XHDMI" connection to the PC using an adapter cable. The maxi-
mum cable length is 3 m. This connection is used to transfer image information
to the operator display.
10.6 Overall connection diagram
USB
PC
display port
Fig. 10-6: Connecting the CDI+ splitter
Mounting, demounting and electric installation
chapter 5.4 "Connecting cables for the CDI
6.
24 V switching input
24 V voltage supply
X1S1
XUSB
CDI+ splitter
XHDMI
6.
CDI+
XCDI+tx1
XCDI+tx2
CDI+
R911400465_Edition 01 Bosch Rexroth AG
19/33
Operator display no. 1
Operator display no. 2
Advertisement
Table of Contents
