Table of Contents
Advertisement
1-10. Switching Search Dial Mode
1-10. Switching Search Dial Mode
There are two kinds of operation to switch the search dial
on the lower control panel between jog mode and shuttle
mode.
. SHUTTLE/JOG button selecting
To enter the shuttle mode, press the SHUTTLE button.
To enter the jog mode, press the JOG button.
. Search dial pressing
When you press the dial, this unit toggles between
shuttle and jog modes.
It is possible to prohibit a manner of toggling.
Prohibiting Search Dial Pressing
1. Open the lower control panel (as shown in the figure.)
2. Loosen a screw on the backside of the search dial as
shown in the figure.
3. Slide the mode selection plate in the direction indicat-
ed by the arrow until it contacts the portion A.
Lower control panel
Back View
Portion A
Screw
1-18
Search dial
Mode selection plate
4. Check to see that the shaft of the search dial is not seen
in the round hole of the mode selection plate, and then
tighten the screw.
Back View
Screw
The shaft is not seen.
Allowing Search Dial Pressing
1. Open the lower control panel (Operation side up).
2. Loosen a screw on the backside of the search dial as
shown in the figure.
3. Slide the mode selection plate in the direction indicat-
ed by the arrow until it contacts the portion B.
4. Check to see that the shaft of the search dial is seen in
the round hole of the mode selection plate, and then
tighten the screw.
Back View
Screw
Portion B
Search dial shaft
The shaft is seen.
Mode selection plate
Round hole
Mode selection plate
Round hole
DNW-A22/A22P
Advertisement
Table of Contents
