8. Install the washer with a groove (A) as the
illustration shows. Install the O-rings (B). Install the
washer (C).
C
B
B
A
9. Turn the second shaft seal press tool to the other
side. Put a new shaft seal on the shaft seal press
tool. Push the third shaft seal into the seal seat.
22 - Repair and servicing
10. Install the snap ring (A) with circlip pliers.
CAUTION: Make sure that the leak hole
does not become blocked.
6.6.7 To remove the ball bearing from the gear
housing
•
Put an inner bearing puller into the ball bearing in
the gear housing. Attach the puller to a slide
Servicing tools on page 6 .
hammer. Refer to
Remove the needle bearing.
A
1332 - 001 - 04.03.2021