It is a must to enable "Auto answer mode" of the
connected Modem in order to answer the dial-in
calls and establish the connections automatically.
Initializing Modem
In the "Modem Operation" menu, press
ENT.
Select "Modem Functions ..", then press
ENT.
Select "Re-Init Modem?", then press ENT
for two seconds to scan and send
initialization command to the Modem.
Baud Rate, Data Routing and Enable Terminal Emulation
Set the desired baud rate, Data Routing direct to port and enable the
Terminal Emulation. Please refer to Chapter 11 on how to set the
Baud rate, Data Routing and Terminal Emulation. The modem is now
ready to answer the dial-in connection.
Establish the Connection from the Remote Terminal
Use a terminal emulation program that supports ANSI or VT-100
terminal emulation modes. In the remote terminal program, dial the
phone number of the modem connected to the AA-3102RS RAID
controller. The modem should answer the call and start "handshaking"
with the modem on the remote site. After the connection is
established, the screen on the remote terminal program will look the
same as the screen on the local site.
222
Modem Operation
..
Modem Functions
..
Re-Init Modem ?
User's Guide