HP 98568A Installation Instruction page 213
Hp 9000 series 300 computers
Hide thumbs
Also See for 98568A:
- Service information manual (142 pages) ,
- Service information manual (144 pages)
Table of Contents
Advertisement
HP 98265A Small Computer Systems Interface (SCSI)
Worksheet Entry
You have now installed the SCSI interface.
The following table contains information needed to use the SCSI interface with
the HP-UX operating system.
Copy this select code to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or simply remember to refer here when you need
it.
When finished, you'll be ready to install your next peripheral or interface.
Table 5-24.
Interface N arne
Select Code
HP 98265A
14
HP-UX Notes
To connect a SCSI-compatible disk drive to the SCSI interface:
1.
Turn your computer and disk drive off, if they are not already off.
2. Make sure the disk drive is a single-ended SCSI disk drive.
3. Attach the cable coming from the SCSI interface to one of the two
connectors on the disk drive (it doesn't matter which one). Press fully in.
4. Place the terminator (supplied with the SCSI interface card) fully on the
other connector on the disk drive.
5. Select a bus address not currently used by any other device on the bus.
6. Turn on the power to the disk drive BEFORE turning the power on to the
computer.
Once you have set up your SCSI disk drive(s) and properly connected the
drives to the computer, you are ready to access the driver using HP-UX.
Remember that the terminator must be attached to the second connector on
the disk drive (step 4 above).
Adding Interface Cards
5-117
- Quick Links:
- Table of Contents
- Getting Started
- Description
Hide quick links:
Advertisement
Chapters
Table of Contents
