HP 98568A Installation Instruction page 168
Hp 9000 series 300 computers
Hide thumbs
Also See for 98568A:
- Service information manual (142 pages) ,
- Service information manual (144 pages)
Table of Contents
Advertisement
HP 98642A 4-Channel Multiplexer Interface
Table 5-15.
Interrupt Switch Switch
Level
2
3
3
0
0
4
0
1
5
1
0
6
1
1
4. Set the Remote Switch.
SKIP?
If you are not connecting your system console to port 1 of
this interface, skip to step 5. The Remote switch is preset to
"local," which does not configure port 1 to be the system
console.
a. Find the group of eight switches on the interface by referring to
Figure 5-29. Switch 1 in this group is the Remote switch.
b. Set the Remote switch as follows:
• If you are connecting a terminal to port 1 of this interface and want
the terminal on port 1 to be the system console, set this switch to
1
(remote), which is opposite that shown in Figure 5-29. Be aware that
the boot ROM will not recognize this terminal as the system console,
even though HP-UX will. No boot ROM messages will appear on the
associated terminal; therefore, do not use the HP 98642A as a system
console until after HP- UX is installed .
• If you are connecting a terminal to port 1 of this interface but do not
want the terminal on port 1 to be the system console, set this switch to
o
(local) as shown in Figure 5-29.
5. Insert the Interface.
a. Remove the painted cover plates from the back of your computer until
you find an empty even-numbered slot. (Slots are numbered from the top
down, so the top-most slot is number 1, the next slot down is number 2,
5-72
Adding Interface Cards
- Quick Links:
- Table of Contents
- Getting Started
- Description
Hide quick links:
Advertisement
Chapters
Table of Contents
