Settings on the Fibre Channel Card (8Gbps FC Card)
2.1.7 Speed and Topology settings
The following describes how to make the Speed and Topology settings.
Note
Do not set [AUTO Loop First - default.] or [AUTO Point to Point first.]. First, make the fixed setting.
Otherwise, the connected device will not be normally recognized.
Static Topology setting
On the [Emulex Adapter Configuration Main Menu] screen, make the following setting that corresponds to the connection
pattern (Fabric connection/FCAL connection).
1. Select [Configure HBA and Boot Parameters], and then press the [Enter] key.
FIGURE 2.14 Static Topology setting (1)
2. Select [Topology Selection <AUTO Loop First –default>], and then press the [Enter] key.
FIGURE 2.15 Static Topology setting (2)
C122-E206-04EN
22